trunnion-topopt
Topology-optimised the A-axis trunnion upright of a 5-axis FDM printer for every tilt direction and belt pull; the v4 design cuts worst-case compliance from 6.8 to 2.0 N mm and belt-pull axle tilt from 28 to 4.6 arcmin, prints without supports, and is checked by fine-mesh FE
Topology optimisation of the A-axis trunnion upright for a 5-axis 3D printer. Instead of one vertical load, the optimiser sees the worst case over the whole tilt envelope plus the overhung belt-pull case, with a 45 degree self-supporting constraint, then every candidate is re-checked on a finer FE mesh.
- Repo: https://github.com/juw12/trunnion-topopt (public, MIT)
- Results page: https://juw12.github.io/trunnion-topopt/ (3D viewer of six designs, metrics, checks, STL/STEP downloads)
- Landing: https://juw12.github.io/p/trunnion-topopt/
- Stack: Python (NumPy/SciPy) 3D SIMP + FE, CadQuery STEP export, three.js viewer
- Recommended part (v4 Tilt gate): 143.5 cm3 / 179 g PA-CF; worst-case compliance 1.96 N mm; axle tilt 4.56 arcmin under 100 N belt pull (target 5); seat deflection worst 25 um; peak von Mises 2.0 MPa; 0 % unsupported overhang; one solid body.
- Baselines: single-load TO (v0) 6.83 N mm / 28.3 arcmin; conventional webbed part (R0) 6.28 N mm / 70.2 arcmin.
- Limits: linear-elastic, isotropic material model; printed anisotropy, fatigue and the real printer's belt load are not measured.
Log
- 2026-11-08: built and honed (v0 to v4, 6 gates pass on v4, results UI by /design bracket, slop_check clean); published repo
efad34b, Pages results site, landing page801209a, profile Engineering entry750e016, portfolio card (art46a98e5, catalog3c24e3e).
See also: GitHub repos